The bindings routine uses this parameter to separate two distinct operations when MV_CTBAMAR = 2, which relies on values General and Lines in the F12 of the routine.
General:
In this option, it operates as it did in the past, displaying the general binding on the browser.
Depending on how you search it on the search bar, you may not find the entity you are looking for in the binding, because the only the first position of the binding is visible in the browser.
Lines:
Option "Lines" shows all binding lines on the browser, whether they are changes and/or new additions.
In this option you can search entities on the search bar, between the lines of the entities that have them. For example:
Searching by account →
We have found two bindings that contain it in the same binding. In this case, to check inside it, use only options edit/view and check which are the entities to which it is bound.
As shown below:
When editing, we can see that it has two lines that contain the binding with account TX001.
Now we can view that it was selected in the first record bound with that entity.
We must emphasize that this parameter only works if used along with parameter MV_CTBAMAR set to 2. |
Note: When you decide to postpone some bindings, the routine may leave a blank line. To correct this, just reselect the desired range of entities and/or deselect the blank line and the routine itself will delete it. You can use this line when you set the message "Do you want to make bindings ?" to No. Exemplification
If you select the line before filtering the entities desired, this may happen:
In this case, we can deselect the blank line:
Note that the previously seen blank line was deleted. |
